SPECIFICATIONS:
•
Saw and Table Unit come
pre-assembled. Tube Holder
should be attached per Assembly
instructions below prior to use.
Check contents for accuracy
immediately upon receipt.
•
Guide Ruler measures from
the Blade ascending to the right
and left. It can be used for
approximate cuts where exact
dimensions are not needed or to
estimate how many tubes can be
cut from remaining length.
•
Saw can cut tubes up to
9/16” diameter tubes in a single
pass. Larger tubes would have to
be turned over for full cuts and
may not be as accurate.
ASSEMBLY:
To allow space for the Clamp to be attached Bolts should be inserted through
Washer and into bottom of table (B1)
Slide Tube Holder onto the Bolt threads
Use small wrench or pliers to hold Stopper Nuts while using Phillips screwdriver
to tighten the Bolts.
Clamping to Table:
Open the clamp (Max. 1-7/8”) and slide the top rod into the hole in the front of
the saw base (B2).
Place Saw on the edge of your table or bench and close the Clamp until saw is
secure
B2
Included Accessories
Saw and Table Unit
(Pre-assembled)
#MLCUTOFF
PSI Woodworking Products
© 2020 PSI Woodworking Philadelphia PA 19115 - v10/20
UNBOXING: