#MLCUTOFF
PSI Woodworking Products
© 2020 PSI Woodworking Philadelphia PA 19115 - v10/20
GENERAL & SPECIFIC SAFETY RULES
1.
KEEP GUARDS IN PLACE and in working order
2.
KEEP WORK AREA CLEAN. Cluttered areas and benches invite accidents
3.
DON’T USE IN DANGEROUS ENVIRONMENT. Don’t use power tools in damp or wet locations or expose them to rain. Keep
work area well lit.
4.
KEEP CHILDREN AWAY. All visitors should be kept a safe distance from work area.
5.
Make Workshop Kid Proof.
6.
DO NOT FORCE TOOL. It will do a better and safer job at the rate for which it was designed.
7.
USE THE RIGHT TOOL. Don’t force tool to do a job for which it was not designed.
8.
WEAR PROPER APPAREL. Do not wear loose clothing, gloves, neckties, rings or other jewelry that can get caught in the
moving parts. Wear non-slip footwear. Tie back and/or cover long hair.
9.
USE SAFETY GOGGLES OR FACE SHIELD. Everyday glasses are NOT safety glasses.
10.
USE FACE OR DUST MASK for operations that generate particulates.
11.
DON’T OVER-REACH. Keep balance and footing at all times.
12.
MAINTAIN TOOLS. For best and safest performance keep tools clean, sharp, and lubricated.
13.
DISCONNECT TOOLS BEFORE SERVICING or changing accessories.
14.
USE RECOMMENDED ACCESSORIES to avoid risk of injury
15.
NEVER STAND ON TOOL.
16.
CHECK FOR DAMAGED PARTS. Before use check for damage and determine if it may interfere with proper operation of
tool. Check for binding and alignment. Damaged guards and parts should be properly replaced.
17.
NEVER LEAVE TOOL RUNNING UNATTENDED! Make sure tool is off and has come to a complete stop.
SPECIFIC SAFETY RULES FOR MICRO TUBE CUTOFF SAW
Read Manual
before Operating Saw
Warning - No adjustments should be made while Saw is in motion.
Warning – Do not use in area where Children may be present
Warning – Do not alter tool to remove Safety Features
Warning – Only cut pen kit tubes with this saw
A)
Wear Eye Protection
B)
Do not wear anything that can be caught in the moving parts
C)
Tighten all locks before operating
D)
Do not press Safety Button prior to pressing Power Switch to on (Dia. A) or turn on saw if blade is already lowered.
E)
Keep fingers away from cutting area when saw is powered on
F)
For use with thin-walled, hollow tubes - do not use for wood blanks or solid rods.
G)
Follow operating instructions in the manual when operating Saw
H)
Do not try to hold tube in place by hand.
I)
To prevent unsafe or crooked cuts, tube must be long enough to be gripped solidly by the Tube Holder.
MICRO PEN TUBE CUTOFF SAW
WITH SIZING JIG