4826 Sterling Drive, Boulder, CO 80301
PH: 720.406.8946 [email protected] www.psaudio.com
®
Getting Started
Getting Started 1
©2008 PS Audio International Inc. All rights reserved.
Owner’s Reference
Juice Bar II
Once your new Juice Bar is unpacked, you’ll need to fi nd a convenient place to set it.
There are several ways to mount the Juice Bar: on the fl oor, on a shelf, or in a rack. If you mount it
on the fl oor, it can either lay fl at on its bottom, or be placed at an angle between the fl oor and the
wall. Note the Juice Bar is shaped in a truncated triangle on the bottom to facilitate placing it in an
angled position.
If your equipment is located a long distance from the Juice Bar, it is preferable to use a long, heavy
gauge shielded power cable between the wall AC receptacle and the Juice Bar, rather than long
individual power cables between the equipment and the Juice Bar.
The Juice Bar can benefi t from aftermarket isolation devices such as cones, spikes and Sorbothane
pads.
Once you have chosen the location for the Juice Bar you can use the supplied AC power cord to
connect it to the AC wall receptacle or you can use an aftermarket power cord and receptacle.
We strongly recommend the use of a PS Audio xStream Power™ AC cable and a PS Power Port™
AC receptacle, or Soloist AC receptacle to feed the Juice Bar electricity. While the supplied power
cable is adequate for the task, it is not going to provide the best performance. Choosing any
xStream Power cable will make a signifi cant performance improvement over the stock power cable.
We recommend the use of a PS Soloist in-wall conditioner to feed this device.
Isolation
Power Cables
Location
Mounting
Conditioners
