Owner’s
Reference
4826 Sterling Drive, Boulder, CO 80301
15-070-01-1
PH: 720.406.8946 [email protected] www.psaudio.com
Rev A2
Owner’s Reference
©2015 PS Audio Inc. All rights reserved.
®
Owner’s Reference
BHK Signature Amplifiers
Plug in the
connecting cables
Turn on the master
power switch
The BHK Signature Amplifier accepts either single ended RCA or balanced XLR connections
to the preamplifier or DAC feeding it. Regardless of the cable chosen, the BHK will treat the
incoming signal in such a way that it becomes balanced throughout the amplifier’s circuitry.
Our preference for connection to the preamplifier is balanced XLR cables. Balanced signals are
lower in noise, provide an extra 6dB of level and take advantage of common mode rejection.
Single ended RCA cables can also be good, but we shy away from their use at lengths
exceeding two meters.
Once connections have been made to both the loudspeakers and the preamplifier, it is time to
plug the AC power source in.
BHK amplifiers are voltage specific. They operate ONLY at the voltage set at the factory. Do NOT
plug the BHK into a voltage other than what it is set for. Failure to observe this rule may damage
the BHK.
Plug a high quality power cable into the BHK IEC AC inlet, the other end into either a P10 Power
Plant, power conditioner, or wall socket of appropriate voltage. Then turn on the master AC
switch.
Plug in the
power cable
6
