8
Before installing this product, turn pump off
CSS 20 Mounting Instructions
·
Mount the CSS 20 Box in a vertical position to a flat surface above the return line to your pool
·
Install the salt generator cell through the mounting brackets with wire
connector leads at bottom
ByPass Installation Instructions
·
Drill holes (use 7/8 hole saw bit) in return line
One 7\8 hole between pump and filter
One 7\8 hold after filter and heater (must be last installation going back to pool)
·
Assemble the Saddle Clamp (see figure A)
·
Attach Saddle Clamp over hole after pump
·
Insert injector into top of Saddle Clamp, push injector through Saddle Clamp into hole in return line
·
Measure and cut clear ¾ hose to fit distance between injector and bottom of salt cell (see figure B)
·
Place two metal clamps on ¾ clear hose
·
Attach one end of ¾ clear hose to top of injector, tighten with metal clamp
·
Attach other end of ¾ clear hose to bottom of salt cell, tighten with metal clamp
Flow
7/8 inch Hole Saw
7/8 Inch hole
Salt Generator Cell
CSS 20 Power Box
A
B
1 1/2 ” Install only
(See 2” on page 4)
Spacer for 1 1/2 ” assembly