12
L1
100% Shock only setting
L2
Mode Switch
L3
Reverse Polarity Cycle LED
L4
Low Salt LED
L5
High Salt LED
L6
Up/Down
L7
% Mode LEDs
MODE SET UP INSTRUCTIONS
How to Adjust Chlorine level in the Pool
1.
When System is turned on initially the three LED’s on the right will blink continuously as follows:
SET-UP FUNCTION
LOW SALT
HIGH SALT
2.
Press the MODE button and the three LEDS will begin flashing on and off together.
3.
Press the MODE button again and the unit will enter the % SET UP MODE.
4.
Select the % VALUE desired (10% is recommended to start ) by pushing the UP or DOWN buttons which will illuminate the
desired PERCENTAGE LEDs.
5.
When the desired % VALUE is selected, press the MODE button to leave the % SET UP MODE. The chlorination cycle will begin.
6.
The 100% VALUE setting should only be used to shock the pool.
Diagram A-2
