User Manual kardiomed cycle 200 med
Version 1.0
Seite 4 von 15
9 The pedals as well as
the cranks are marked
with the side (R/L). Screw
the left crank and left
pedal together.
10 Place the crank onto
the axis and fix with
the axis screw (B) with a
14mm socket. Tighten
the crank very strong
(Retighten chapter 6.2)
11 For the finish covert
he axis screw with a
cover cap (C).
12 Repeat steps 9 to 11
with the right side.
Important: Beware that
you mount the cranks
right and left 180°
offset.
13 Next the monitor gets
fixed. Therefore unscrew
the four outer screws of
the monitor backside.
14 Carefully open the
casing and lead the red
cable coming out of the
unit mast through the
according hole on the
backside of the
monitor.
15 Place the plug on the
horizontal placed socket.
You can recognize the
proper lock in place by a
„klick“.
16 Next the monitor
front gets put back on
and the monitor gets
fixed with the four
screws (D).
17 Afterwards the 4
outer casing screws get
screwed back in to seal
the casing properly.
18 The flat steel bar is
loosely premounted
with two setscrews in
the handlebar socket.
Remove the right screw
only and insert the
right part of the
handlebar…
19 …and fix this part
with the setscrew
loosely.
20 Next loosen the left
screw and repeat the
past two steps with the
left side.
21 Adjust the handlebar
that the handles are
parallel with the
monitor front…
22 …in this position the
setscrews get finally
tightened.
Finished!
