20
4
Storage, transport and installation
The devices are usually delivered completely assembled. In rare cases, it may be necessary to ship the
units partially disassembled for transport reasons. In these cases, please use the corresponding assembly
instructions at the service [email protected] and follow the instructions given there!
Surroundings
●
Only in dry rooms free from seawater air (>65% humidity).
●
Avoiding temperatures below 5 °C and above 45 °C.
●
Avoid placing the units in heavily frequented rooms or near doors and
passageways.
Substrate
●
The bearing capacity of the substrate must be according to the weight
of the device.
●
Level and impact-resistant surface that can withstand the load of the
device and the maximum permissible body weight of the user of 200 kg.
●
Small unevenness of the floor can be compensated for by means of the
adjustable feet which can be attached to the unit.
●
Or a level surface must be created by using suitable shim material made
of shims or heavy-duty plastic.
●
The balancing materials should not be susceptible to rust.
●
When changing the position without disassembling the training device,
make sure that the device is standing securely on level ground.
●
For PVC floors: the rubber sheets may cause reactions with the PVC floor,
in this case use appropriate cork sheets.
Setting up the
device
●
Avoid hard, impact-like contact with the equipment.
●
Compensation of unevenness via adjustable feet, which can be adjusted
in your height. Alignment with a spirit level.
●
Protect the devices from shocks, scratches and moisture.
