3-4
Chapter Three
Selecting a single slide
The current slide has a blue background in the
label
. To select a different
slide, point to the slide and press the MouseDisk or Cyclops wand button,
or activate the high-intensity laser spot.
Selecting multiple slides
To select multiple slides so that you can move or modify them as a group,
just turn on Multiple Select Mode, then select each slide, one at a time with
the Cyclops remote (press the edges of the MouseDisk to reach a slide, then
press the center of the MouseDisk), wand, or optional laser pointer. Selected
slides are surrounded by a blue outline.
If you select a slide by mistake, choose it again to “deselect” it.
Note:
Selected slides have a blue outline around them. This is different from
the current slide, which has a blue label. A slide can be selected yet not be
the current slide.
Dragging to select multiple slides
To drag select consecutive slides, start just before the first slide in the group,
then drag a selection box around the slides you want. When you release the
selection box, a blue outline appears around each slide in the group you
chose.
Note:
After you finish, it’s a good idea to turn Multiple Select Mode off.
Dragging is easy—just click and drag as you would with a mouse.
To drag select several slides, follow these steps:
1. Use the Cyclops remote control, wand, or optional laser pointer to move
the mouse pointer above and to the left of the first slide that you want to
select.
2. Press the MouseDisk for at least one second then release, or press and
hold the Cyclops wand button or high-intensity laser.
3. Press the edges of the MouseDisk, or move the Cyclops wand or laser
pointer while holding down the button, to move to the last slide that you
want to select. As you drag, the box expands, as shown in Figure 3-2.
