Proxima DP1200x, User Manual

Page: 33 / 46

31
Settings menu
Audio
: allows volume adjustments. You can also adjust volume from the
keypad.
Sources
:
allows you to assign a particular input to a specific source key
when using certain optional remotes. Also allows selection of a default
Power-up Source and enables or disables Autosource. When Autosource is
not checked, the projector defaults to the source selected in Power-up
Source. If no source is found, a blank screen displays. When Autosource is
checked, Power-up Source determines which source the projector defaults
to at power-up. If no signal is present, the projector checks the sources in
order until a source is found or until power down.
Power-up Source:
determines which source (computer or video) the projec-
tor checks first for active video during power-up.
System menu
Rear:
reverses the image so you can project from behind a translucent
screen.
Auto Power
: When Auto Power is checked, the projector turns on when
power is applied and turns off if a source becomes inactive.
Display Messages : displays status messages (such as “Searching” or
“Mute”) in the lower-left corner of the screen.
Lamp Mode
: allows you to optimize the lamp mode for your specific use.
The default is High Bright, which maximizes the light output. Select Long
Life to maximize lamp life and minimize fan noise, or Nominal to balance
brightness, lamp life, and fan noise.
NND (Notebook No-Doze)
: prevents your notebook computer from going
into Screen Save mode (functions only when the USB connector is plugged
in).
Power Save : automatically turns the lamp off after no signals are detected
for 20 minutes. After 10 additional minutes with no signal, the projector
powers down. If an active signal is received before the projector powers
down, the image will be displayed.
Audio
Sources
Power-up
Source
System menu
Lamp mode