Page 10
Copyright © 007 Proxim Wireless
step.3:.attach.cables
cabling.without.Power.over.ethernet.(Poe)
Plug the barrel of the power cable from the power supply into the power
jack (the leftmost port in the back of the unit, see figure).
Connect one end of an Ethernet cable (not supplied) to the unit’s LAN
port (see figure). The other end of the cable should not be connected to
another device until after installation is complete:
Use a straight-through Ethernet cable if you intend to connect the
5012/5054-SUI to a switch, hub, or patch panel
Use a cross-over Ethernet cable or adapter if you intend to connect the
5012/5054-SUI to a single computer.
Continue with “Install the Security Cover”.
cabling.without.Power.over.ethernet.(Poe)
You must use an Active Ethernet adapter such as the ORiNOCO 1-Port
Active Ethernet DC Injector (ordered separately). Connect one end of an
Ethernet cable (not supplied) to the unit’s LAN port. Connect the other end
to the Data and Power Out port of the DC Injector (see figure).
Connect one end of a second Ethernet cable (not supplied) to the Data In
port of the DC Injector (see figure). The other end of the cable should not
be connected to another device until after installation is complete:
Use a straight-through Ethernet cable if you intend to connect the
5012/5054-SUI to a switch, hub, or patch panel.
Use a cross-over Ethernet cable or adapter if you intend to connect the
5012/5054-SUI to a single computer.
1.
2.
º
º
3.
1.
2.
º
º
