Configuration
Tsunami MP.11 5012/5054-SUI Installation and Management
Network Parameters
66
The following parameters are configurable:
•
DHCP Server Status:
Verify that DHCP Relay Agent is disabled. After you have made at least one entry in the DHCP
server IP Pool Table, enable DHCP Server by selecting
Enable
from the
DHCP Server Status
pull-down menu.
NOTE:
There must be at least one entry in the DHCP server IP Pool Table to enable DHCP server. Also, DHCP
server cannot be enabled if DHCP Relay Agent is enabled.
•
Subnet Mask:
The unit supplies this subnet mask in its DHCP response to a DHCP request from an Ethernet host.
Indicates the IP subnet mask assigned to hosts on the Ethernet side using DHCP.
•
Gateway IP Address:
The unit supplies this gateway IP address in the DHCP response. It indicates the IP address of
a router assigned as the default gateway for hosts on the Ethernet side. This parameter must be set.
•
Primary DNS IP Address:
The unit supplies this primary DNS IP address in the DHCP response. It indicates the IP
address of the primary DNS server that hosts on the Ethernet side uses to resolve Internet host names to IP
addresses. This parameter must be set.
•
Secondary DNS IP Address:
The unit supplies this secondary DNS IP address in the DHCP response.
•
Number of IP Pool Table Entries:
The number of IP pool table entries is a read-only field that indicates the total
number of entries in the DHCP server IP Pool Table. See
Add Entries to the DHCP Server IP Pool Table
Add Entries to the DHCP Server IP Pool Table
You can add up to 20 entries in the IP Pool Table. An IP address can be added if the entry’s network ID is the same as the
network ID of the device.
NOTE:
After adding entries, you must reboot the unit before the values take effect.
1. To add an entry click
Add Table Entries
.
