ProX BlitzzFX Operators Manual
Page 3
Version: 1.4 (9/6/2019 9:45 AM AD)
USE PROX BRANDED SPARK POWDER ONLY!
•
CERTIFIED ADULT OPERATOR USE ONLY
•
DO NOT OPERATE WITHOUT SPARK POWDER.
•
DO NOT SHOOT TOWARD PEOPLE OR COMBUSTABLES.
•
ALLOW MINIMUM 10 FT BETWEEN SPARK PORT
AND SPECTATORS/GUESTS/DECORATIONS.
•
KEEP DRY - IP20 – STORE IN A SECURED DRY AREA
•
DISCONNECT POWER BEFORE CHANGING FUSE.
•
DO NOT OPEN THE CASE, RISK OF ELECTRIC SHOCK!
•
NO USER SERVICEABLE PARTS INSIDE.
Details:
1.
Spark Output
(DO NOT ADD POWDER HERE!)
2.
Cap for Powder Loading
3.
Lifting Handles
4.
Fuse 8 Amp.
5.
On/Off Switch
6.
USB Connector
(for future firmware updating)
7.
DMX-512 Connector In/Out
8.
115V AC Power Out
9.
115V AC Power In
10.
Wired Controller Connector
11.
Safety Card Scan Area
12.
LCD Digital Display
Operation
•
Have the device operated by a qualified person, respecting IEC 60598-2-17 and all other applicable codes
•
Never stand directly below the device when it is being mounted, removed or serviced. Have a qualified
technician check the device annually and additionally before placing into service if stored for an extended
period of time.
•
Install the device in a secure location that is inaccessible to unauthorized persons.
•
Make sure there is no flammable material within a 10ft radius of the device.
•
Use a clean and dry rag to remove dust. Metal parts can be cleaned with a damp cleaning rag.
1.
Open the transport case and carefully remove each unit.
2.
Set the BlitzzFX vertical on a firm flat dry surface. Do not invert or lay ln side!
3.
Fill the powder reservoir with our ProX powder only then tighten the cap.
Safety card is in powder bag.
4.
Scan the safety card AFTER loading powder. Card is SINGLE use!
5.
Press MENU button to check remaining time after each use if desired. Remaining time shown as seconds.
6.
Firmly attach the remote-control unit to the rear remote-control socket on the unit.
7.
Plug the unit in to a proper power source. Wait several minutes for the device to reach normal operating
temperature. When it has reached the operating temperature, and is ready to operate with sparks, the
digital display board at rear will show “READ” and the ready LED on the remote will glow also.
8.
You can press wired controller or wireless controller or DMX to emit output.
