background image


 

IMPORTANT SAFETY CONSIDERATIONS: 

 

1.

 

 With power disconnected, place the UNIT horizontally, and inspect it for damage on all sides 
before each use.   If damaged, do not operate and contact ProX for service.  

2.

 

Unscrew the lid of the powder tank to pour in the ProX powder, and then lightly tighten the lid. 
(Use ONLY ProX branded powder) 

3.

 

Before power on, please verify that the supply voltage is in conformity with the rated voltage of 
the machine. At power on, the indicator light will turn on, and the machine will begin to heat for 
use.  Connect the machine to your preferred controller. 

4.

 

The machine must be used only in a well ventilated place.  Although this is a COLD effect, it does 
create a small amount of smoke/haze during operation. 

5.

 

Do not allow machine to run out of powder. If the machine is allowed to run empty, it may cause 
the mechanical system to be damaged.    
IMPORTANT: Turn off the power before adding effect powder. 

6.

 

Do not touch the device during operation as the housing will be hot to touch.  Provide a minimum 
of 3 foot clear  

7.

 

Keep this device in a dry area at all times. 

8.

 

Disconnect all power before opening the housing for any reason. 

9.

 

Damage caused from not following the guidelines in this manual are not covered by the warranty 
and ProX will not accept responsibility for any resulting defects or problems. 

10.

 

A qualified technician should install and service this device. 

11.

 

Do  not  switch  the  device  on  immediately  after  it  has  been  exposed  to  extreme  changes  in 
temperature  especially  very  cold  conditions.  Protect  the  device  against  damage  by  leaving  it 
switched off until it has reached room temperature. 

12.

 

This  device  falls  under  NEC  Class  1.  It  is  essential  that  the  device  be  earth  grounded.  Do  not 
remove or isolate the grounding pin. 

13.

 

Make  sure  that  the  available  voltage  does  not  exceed  the  voltage  stated  in  the  specification 
section of this manual. 

14.

 

Do  not  crimp  the  power  cord.  Protect  it  against  damage.  Have  an  authorized  service  center 
replace it if necessary. 

15.

 

Disconnect the device from all power to clean it or when it is not in use. Handle the power cord 
by the plug ends only. 

16.

 

Note that ANY modification to the device is not covered by the product warranty and will VOID 
the warranty. 

17.

 

Keep the device away from children and untrained/unauthorized users. 

 

 

USE PROX SPARK POWDER ONLY! 

 

ADULT USE ONLY 

 

DO NOT OPERATE WITHOUT SPARK POWDER. 

 

DO NOT SHOOT TOWARD THE AUDIENCE OR PEOPLE. 

 

ALLOW MINIMUM 8FT BETWEEN THIS DEVICE AND SPECTATORS/GUESTS. 

 

KEEP DRY - IP20 

Summary of Contents for X-BLITZZ








Reviews: