19
18
Specifications
Specifications
Version 1.0
| 19 |
| 18 |
Version 1.0
Operation
Take some time and practice using it before pull or lift a load, that way you will be familiar with all the opera-
tions.
The following steps describe how to use the tool with single cable. A snatch block can improve the pulling
capacity.
1.
Put on gloves and attach the strap to the hook.
2.
Install the battery. Make sure the position of power switch is at “OFF /O”. Put the battery into this product,
ensure the latch is fully engaged.
3.
Power on the tool. Turn the power switch to the position “ON/I”. Always turn the power switch to “OFF”
when not in use.
4.
Spool out. Press the directional switch to “ “ then press and hold the speed controller. Always keep some
tension on the cable to prevent bind and entangle the cable, causing damage to it and the product. Never
spool the cable out pass the red painted on the cable.
5.
Secure and anchor point. Using the swiveling anchor hook to attach the anchor point. Always make sure
that the anchor you intend to use is capable is withstanding the load. Never hook the cable onto itself. This
could damage the cable. A tree saver or choker chain is recommended.
6.
Attach you load. Establish a load point, use a shackle or strap when attaching the hook to your load.
Always hook with a latch and insure hook latch is secure.
7.
Give the cable some tension. Press the directional switch to “ “ then press and hold the speed controller
to slowly wind the cable until the cable is winded tightly. Never touch cable or hook while in tension or under
load.
8.
Using a damper when pulling. When pulling, put a damper, blanket or other heavy-duty material over
the cable.
9.
Plan to pull or lift. Ensure all the connections are secured. Line up your pulling directions as straight as
possible. Side pulls can cause the cable to bunch at one side of the drum, damage cable and the product.
10.
Start pulling or lifting. Press the directional switch to “ “ then press and hold the speed controller to
wind in the cable. Never exceed pulling capacity listed on product data sheet. Double the cable number using
a snatch block to reduce load.
1 - 6.5 Ft
7.5 - 13 Ft
+ 13 Ft
Operation
11.
Disconnect the hook from load and anchor point. Be sure to secure the load completely. Press
the directional switch to “ “ then press and hold the speed controller release tension in the cable.
Disconnect the hook from the load and anchor point.
12.
Rewind cable. Press the directional switch to “ “, then press and hold the speed controller
to slowly wind in the cable. Always keep a tension on the cable to prevent bind and entangle the
cable, causing damage to it and the tool. Do not let cable slide through your hand.
13.
Turn off the pulling tool. Make sure the position of power switch is “OFF /O” Store in a clean and
dry place and avoid children to contact and play.
The operation is now complete.
•
Always spend some time check the load and determine whether the load is within
the specified load range of the product.
•
Always check the product for malfunction and battery status.
•
Always wear gloves to prevent injury of hands caused by steel cables.
•
Always pay attention to the safety of yourself and people around you.
•
Practice over and over again.