7
8
PR
EP
A
RE
7
PR
EP
A
RE
7
Adhere transparency, printed side up,
to the glass on the Yudu machine using
clear tape.
For single color designs, go to "Exposing
Screen" on page 8.
Tape second design layer to second registration
panel, stacking the images, and ensuring it is
registered with first layer. Repeat for each
design layer.
When design layers are secured to registration
panels, remove all but the first panel.
5. mUlTICOlOReD DesIgNs:
Press light table button.
4. sINgle COlOReD DesIgNs:
Place first registration panel on
registration posts.
Mount first design layer to registration
panel with clear tape.
Run squeegee over the shiny surface of
the emulsion.
TIP: Inspect front of the screen for any bubbles or dry
areas. Dry areas will have a spiderweb pattern. Use spray
bottle with water to
lightly mist
any dry areas.
Squeegee
both sides of screen to eliminate excess water prior to
drying
. Dry edges of screen with a paper towel or cloth.
Place screen in drying rack of Yudu machine.
Press fan button to begin a 20 minute drying
cycle. The fan will stop and the machine will beep at the
close of the cycle. In drier climates the screen may dry
after as little as one cycle. In more humid climates the
drying process may require several cycles. For humid
climates you may blot moisture from the underside
of the screen with a dry cloth towel and/or squeegee
excess moisture from the screen to speed the drying
process. Test for dryness before moving on to the next
steps.
After emulsion has dried, remove plastic film.
TIP: A hair dryer can be used to accelerate the
drying process.
TIP: Leaving door open while drying will speed up
the process. Repeat the drying process if necessary.
