Page 17
IP CAMERA USER MANUAL
2. There are two options for IP setup: obtain an IP address auto by DHCP protocol and use the
following IP address. You may choose one of options as required.
3. Use the following IP address: display the IP address, subnet mask, gateway and DNS of the
device.
4. PPPoE: User needs to manual input the user name and password for dial-up internet.
Firstly, log in IE clients and then enter user name and password of PPPoE, save the setting
and exit. Secondly, set up IP address change notice. Thirdly, connect with Modem. Then the
device will dial up internet automatically.
5. Press the “Save” button to save the settings.
4.4.3
Server Configuration
Go to “Network Configuration”
“Server Config”.
1. Check “Do you want IP Camera to connect Server”.
2. Check the IP address and port of the transfer media server in the CMS/NVMS. Then enable
the auto report in the CMS/NVMS when adding a new device. Next, self-define the device ID
and input the remaining information of the device in the CMS/NVMS.
3. Input the above-mentioned server IP, server port and device ID in the responding boxes.
4.Click “Save” button to save the settings.
4.4.4
IP Notify
1. Go to “Network Configuration”
“IP Notify” to see a tab as shown below.
2. If the “Enable notifying change of IP” is selected, when the IP address of the device is
changed, a new IP address will be sent to the appointed mailbox automatically; If “FTP” is
selected, when the IP address of the device was changed, a new IP address will be sent to FTP
server.
Summary of Contents for DAI-310IP04
Page 1: ......
