IP Camera User Manual-15
C
C
C
h
h
h
a
a
a
p
p
p
t
t
t
e
e
e
r
r
r
6
6
6
V
V
V
i
i
i
d
d
d
e
e
e
o
o
o
S
S
S
e
e
e
a
a
a
r
r
r
c
c
c
h
h
h
2. Tick off “Enable/Disable PTZ Config”, and then reboot IE client side, the PTZ control
panel will be displayed on the live interface.
3. Select the protocol of the PTZ device at the "Protocol" pull down list.
4. Input address of the PTZ in the "Address" textbox.
5. Select baud rate of the PTZ in the "Baud rate" pull down list.
For the settings of protocol, address and baud rate please refer to the user manual of the
PTZ setting.
5.3.2
Preset Configuration
1. Enter into "PTZ Configuration"
"Preset" to see a interface as shown below:
2. Input the preset number and set its position by controlling PTZ control panel and then click
Add button to add preset point into the Available position list.
3. Select the preset in the pull down list of the Available position and click Go to button to
move the dome to this preset point; click Delete button to delete checked preset point.
4. After finishing setting, click Save button to save the settings
Button
Meanings
to rotate the dome upwards;
to rotate the dome downwards;
to rotate the dome towards left;
to rotate the dome towards right;
to stop rotating the dome.
Focus button. Click
button to have long focus; click
button
to have short focus.
Zoom button. Click
button to zoom in the locale picture ; click
button to zoom out the locale picture.
Iris button. Click
button to increase light of the dome; click
button to decrease the light of the dome.
Drag the scroll bar to adjust rotating speed of the dome.
5.3.3
Cruise Configuration
Enter into "PTZ Configuration"
"Cruise" to display a interface as shown below:
Summary of Contents for BX-390IP
Page 3: ......