START-UP PROCEDURE
NOTE:
1. If after 30 seconds, it has not recognized the drone, turn off the controller
and repeat Start-Up procedure.
Before flying, the drone and transmitter must be turned on in sequence
and synchronized.
1. Turn on the drone by pressing the on button and holding for 3 seconds. The
lights on the drone will flash to indicate it’s on. Place it on an even surface.
The green lights on the drone are at the front and the red are at the back.
2. Turn on the remote control.
3. Push the throttle the down and then release. The remote will beep three times
and the flashing lights on the drone and remote will turn steady to indicate it
has synced.
4. Your drone is now synchronized, and in stand-by mode awaiting Engine
Idle command.
STARTING THE ENGINE; ENGINE IDLE
After synchronizing the drone, move the throttle and direction sticks in to the lower
center corners (copper lines) and release to go into Idle mode. The blades will
rotate but the drone will not lift.
6
Summary of Contents for VENTO WIFI
Page 1: ...INSTRUCTION MANUAL VENTO WIFI DRONE WITH LIVE STREAMING CAMERA...
Page 2: ......
Page 20: ......