START-UP PROCEDURE
NOTE:
1. While the drone is in process of synchronizing or calibrating, the lights
will flash quickly. When the process is completed, the lights will go
steady. This is your indication that the process is completed.
2. If after 30 seconds, it has not recognized the drone, turn off the controller
and repeat Start-Up procedure.
3. If the Dronium 3X is unsteady in flight, it may not have been able to
calibrate properly. Power down both drone and remote and restart
pre-flight procedure, including re-calibration of the altitude sensor.
4. For the Altitude Sensor to calibrate properly, the drone must be
synchronized already, but the engines not spinning yet. You cannot
calibrate while the propellers are turning. You have to calibrate before
you start the engines.
Before flying, the drone and transmitter must be turned on in sequence and
synchronized. Once synchronized, you must press the calibration button so the
Altitude Sensor can set properly.
1. Turn on the drone and place it on an even surface. The white lights on the
drone are at the front and the red are at the back.
2. Turn on the remote control.
3. Both indicators on the drone and the remote will flash while they are syncing.
4. Push the throttle up and then down to sync. You will hear two beeps and the
lights will go steady.
5. Next, you must calibrate the Altitude Sensor. Press the calibration button
once. Lights will flash quickly and will go steady when finished. Your drone
is now synchronized, calibrated, and in stand-by mode awaiting Engine
Idle command.
6
