Installing the Lens
Tip:
PROTO¤ replacement lenses come with a protective film on the inside of the
thermal lens. Leave the protective film on during installation. Remove the
protective film before use.
Install the lens in the goggle frame.
1
Insert new lens into lens frame.
2
Make sure lens is fully seated and logo block is placed firmly
into frame receiver.
[See figure 1]
3
Make sure bottom edge of lens is fully seated within
lens retention ribs.
4
While holding the lens and frame firmly at top logo area,
insert frame hook into large hole at top of nose on mask.
[See figure 2]
5
Once hook is in place, roll lens/frame towards
mask and push down.
6
Make sure frame is flush with mask and fully seated
at nose area.
7
Align Switch“ lock holes and replace Switch“ locks in
opposite manner removed.
[See figure 3]
8
Replace strap under retainer clips.
WARNING:
If the lens is not completely
seated in hard goggle frame, the lens
may separate during use and cause injury.
16
2
1
3
Remove the Lens from Goggle Frame
1
With both Switch™ lock tabs fully removed, place finger between frame
and hard goggle at top center, and pivot frame forward at nose.
2
After pivoting forward, lift lens and frame out of mask.
3
Pop lens out of frame.
15
Removing Lens Continued
