18
MESSAGES
The trunk system has two message inputs, each mes-
sage can display up to 10 characters. These mes-
sages are activated on the LCD display when the “in
trunk system” gets a signal from the interface cable (if
siren or lights are on). See the Installation section for
the connections (pin-outs) of the interface cable. By
default the “SRN” message appears on the screen when
the siren is on. Similarly, the “LTS” message appears
on the screen when the lights are turned on. The mes-
sage “Record” comes on when an input is received
(Lights or Sirens) by the VCR and the VCR begins re-
cording.
1
Press and hold the “Stop” button of the IR re-
mote control for 5 seconds and the main menu
will pop up on the screen.
2
Place the cursor in front of “Message” using
the “+” or “-” button.
S e t M e s s a g e
M e s s a g e 1
M e s s a g e 1 R e c o r d O N
M e s s a g e 2
M e s s a g e 2 R e c o r d O N
M e s s a g e 3
M e s s a g e 3 R e c o r d O N
E x it
3
To make a selection press the “F.F.” button,
and the above menu will pop up on the screen.
4
Place the cursor in front of the message that
you want to change and press the “F.F.” but-
ton.
5
A blinking cursor will appear the screen.
6
Enter the letter or numeric character, using the
“+” or “-” buttons.
7
After entering the first letter press the “F.F.” but-
ton to move the cursor to the next place.
8
Again use the “+” or “-” button to select the
next letter.
9
Repeat steps 6 to 8 until you enter the com-
plete title.
10
After entering the title press the “Stop” button,
it will return you to the Message sub menu.
11
After entering the title, place the cursor in front
of Message “1 Record” and press the “F.F.” but-
ton.
12
Press the “+” or “-” buttons to turn the message
recording ON or OFF.
13
Enter message 2 the same way message 1
was entered.
14
Exit all of the menus to activate your selection.
RECORD SETTINGS
Access the sub menu of the Record Setting by placing
the arrow next to Record setting and press the “F.F.”
button. The following sub menu will appear:
Recording S etting
Recycle Rec O F F
Rec- over Protect O F F
Power- up Record O F F
Alarm Rec Dwell 3min
Exit
RECYCLE RECORD
If you turn on this feature, at the end of the tape, the
VCR will automatically rewind the tape and record over
previous recorded information.
REC OVER PROTECT
If you turn on this feature, the VCR will NOT record over
previous recorded information. Instead it will search the
tape to find the end of the recording and begin the new
recording there.
POWER-UP REC
If you turn on this feature, the VCR will begin recording
as soon as the VCR is powered up.
Note: A tape must be in the VCR to begin “Power-Up
Rec”.
