11
Installation
To properly install the Prosecutor 2000 System, please read and perform each of the following steps in order.
Preparation
Disconnect the car battery cables. Remove the lower half of the rear seat. Remove the kick panel and trim strips on
front and rear passenger side of the car. Remove or loosen the lower half of the trim on the door post between the front
and the rear door enough to get cables under.
Camera Mount
Remove the mount foot from the camera mount. If you are using a windshield mounted camera, mount the foot to the
window by following the directions on the included adhesive package, making sure to follow the instructions exactly.
If you are not mounting the camera to the windshield, follow the directions on the adhesive package and mount the foot
in the desired location, paying special attention not to obstruct air bag deployment. Allow adhesive to set until the end
of the installation before mounting the camera.
LED
The LED wire connection will hook into the rear of the Control head. Place the LED cable somewhere on the front
dashboard, making the LED end visible outside the front windshield of the vehicle. (On the driver side of the
windshield is recommended. This way the cable can be placed up the side panel and run across the edge of the
headliner to the rear connection of the control head.)
Trunk Unit Mount
Place the unit in the desired location of the trunk. Make sure that the unit can be unlocked and opened easily, and
tapes can be loaded and ejected conveniently.
Unlock the unit and remove the base plate. Pay attention to the location of the gas tank. If this is a Crown Victoria
installation, use the mounting brackets.
Note: If the unit is going to be mounted on the shelf next to the spare tire, special care must be taken to avoid drilling
into the gas tank and the mounting brackets must be used.
Assembly of the mounting brackets
to the base plate of vault
Mounting of the mounting brackets
with base plate of vault attached
Completed assembly of brackets
and base plate of vault
Checking accessibility of vault and
tape insertion
