Polski Rejestr Statków S.A. al. gen. Józefa Hallera 126, 80-
416 Gdańsk, Poland
According to European standard EN365:2004 and EN795:2012 type B a requirement to check the legibility of the product
PROTEKT Grzegorz Łaszkiewicz ul.Starorudzka 9 93
-
403 Łódź
2. Overall dimensions of connecting lanyard
4. Periodic inspections
KEY:
L=usable length
Q=length of cut rope
At least once a year, after every 12 months of use, it is necessary to carry out
periodic detailed inspection of the device.
Periodic inspection shall be carried out by service point authorized by the
Manufacturer located at the following address:
PROTEKT Grzegorz Łaszkiewicz
ul. Starorudzka 9
93-
403 Łódź
or a competent person with adequate skills, trained in performing
inspections of such equipment.
A trained person is a person who, based on own specialized education and
adequate experience, has sufficient knowledge in installed protective and
rescue equipment, and is familiarized with applicable OHS regulations,
guidelines and generally acknowledged technical rules to such extent that is
able to assess safety of use and correct application of protection devices.
After 5 years of use, it is recommended that periodic inspections are carried
out by the manufacturer of the equipment or an entity authorised by the
manufacturer to carry out such inspections.
Before each use of the system check whether date of the next inspection is
not expired. Do not use the device after this date. Before each use of the
system visually check the system for its integrity and technical condition and
whether steel cable is tensioned.
If any defect or lack of integrity is found, do not use the point.
If any doubts arise as regards the use of the equipment, please contact the
manufacturer and never repair the equipment on your own!
A system which has been used to arrest a fall must be withdrawn from use
immediately!
The system which has been used to arrest a fall may be admitted for use
again after a detailed inspection is carried out by the manufacturer or an
authorized service point.
When using the system, pay special attention to risks affecting the
protective equipment operation or the user’s safety, and in particular to
kinks and rope movement on sharp edges, oscillatory falls, electricity,
influence of extreme temperatures, equipment damage, adverse
environmental factors, chemical substances and contamination.
Neither modify, repair components of the system nor replace them with
non-original spare parts.
Figure 2. Overall dimensions AZ411
3. Time of usage
Maximum time of usage of correctly operating devices is unlimited.
The device must be withdrawn from use immediately and destroyed if it has
been used to arrest a fall or there are any doubts concerning its function.
NOTE
: Maximum time of usage of the device depends on intensity and
environment of use. If the device is used in heavy conditions, being exposed
to frequent contact with water, sharp edges, corrosive substances, extreme
of temperatures, it may be necessary to withdraw the device after only one
use.
