Protector WA-5, Operating Instructions Manual

Page: 10 / 28

WA-5 | ENGLISH
10
13 = Attachment hole
14 = Ring cable lug
OPERATION
Insert a water detector into a suitable mains socket
and connect any device you wish to protect into the
socket on the water detector.
Use the slider on the side (11) to select whether a
connected device should be switched ON or OFF.
As soon as the water detector detects water an
alarm will sound for approx. 2 minutes and the
socket will switch ON or OFF in accordance with this
selector switch. The alarm LED and the socket can
only be cancelled using the RESET button. To do this
press the button briefly once after the sensor is no
longer in contact with water. Then the device can
detect water again.
The POWER LED (5) shows whether the socket on
the water detector is conducting electricity (LED
lights up) or is switched off (LED not lit).
You should check the water detector for function at
regular intervals. To do this submerge the sensor
electrodes (9) briefly in tap water. If no alarm
sounds see the section ‘malfunction’.
MOUNTING
The sensor can be opened by removing the screw
(7). There is a small hole (13) on the back of the
sensor so that the sensor can be mounted at its
Thank you for purchasing the WA-5 water detector.
Please read these operating instructions through
carefully before initial operation of the device and
retain them for any later use.
This water detector is used to switch connected
devices (to a maximum of 2000 watts) ON or OFF
as soon as the sensor comes into contact with water.
Once the water detector has detected water an
alarm also sounds.
This water detector is only authorised for indoor use
and may not be arranged successively.
Scope of delivery
1x Water detector including 2 m sensor cable
and sensor
2x Ring cable lugs
1x Attachment material
1x Instructions
LEGEND
1 = Water detector
2 = ALARM LED
3 = RESET button
4 = Loudspeaker for alarm
5 = Power LED
6 = Sensor cable (2m)
7 = Sensor casing screw
8 = Sensor
9 = Sensor electrode
10 = Alarm volume switch
11 = Function selector switch
12 = Electrode screws
RECEIVER