Troubleshooting of E devices
Arrranged by:
Péter Erdős
Zoltán Seida
PR-MU-27-11
Valid from:
2016-01-22
Page: 20 / 28
Approved by: László Eperjesi
Revision: 1
8
Warning and Error Messages
Inappropriate or faulty conditions cause the device to give warning or error
messages which can be seen in the
advanced
status/log
menu below the
Warnings and Errors
point. In some cases the warning/error message can also
be seen on the local display of the device.
8.1 Warning messages on the web page
In case of warnings the status LED turns usually yellow (exceptions are shown in
the table below), and a yellow triangle appears on the web page below the menu
list with an exclamation mark in it.
In this case several functions are unable to work depending on the fault. The
possible messages are listed in the table below.
Figure 8-1 Warning message on the web page
Warning message (RDSP)
Explanation
0x0100 Card detection
More modules are detected than configured in
the configuration
0x0010 PS unstable
Power supplies with auxiliary voltage monitor
(PS+xxx2) detect unstable voltage
Warning message (CDSP)
Explanation
0x0020 Time sync
This warning appears if the “Timesync
warning” parameter is set in the
system
parameters
Time synchronization
menu
and no synchronization signal is detected.
