protech PS6508 Series, User Manual

Page: 15 / 86

Chapter 1 Introduction
Page: 1-10
PS6508 SERIES USER
′
S MANUAL
1-4. SAFETY PRECAUTIONS
Following messages are safety reminders on how to protect your systems from
damages. And thus, helps you lengthen the life cycle of the system.
1. Check the Line Voltage
a. The operating voltage for the power supply should cover the range of
100VAC-240VAC, otherwise the system may be damaged.
2. Environmental Conditions
a. Place your PS6508 on a sturdy, level surface. Be sure to allow enough
room on each side to have easy access.
b. Avoid extremely hot or cold places to install your PS6508 Book-sized
PC.
c. Avoid exposure to sunlight for a long period of time (for example in a
closed car in summer time. Also avoid the system from any heating
device.). Or do not use PS6508 when it‘s been left outdoors in a cold
winter day.
d. Bear in mind that the operating ambient temperature is from 0
°
C up to
+35
°
C.
e. Avoid moving the system rapidly from a hot place to a cold place or vice
versa because condensation may come from inside of the system.
f. Place PS6508 against strong vibrations, which may cause hard disk
failure.
g. Do not place the system too close to any radio active device. Radio-
active device may cause interference.
h. Always shutdown the operation system before turning off the power.
3. Handling
a. Avoid putting heavy objects on top of the system.
b. The power of COM1 and COM4 is co-used with 2
nd
display, please be
sure COM1 and COM4 are set at RI mode while using 2
nd
display.
Otherwise, COM1 and COM4 may cause operating problem.
c. If the system isn’t full system in DOS mode, please adjust BIOS setting
as following instruction.
Advanced Chipset Feature => Boot display => choose “LFP”
4. Good Care
a. When the outside of the case is stained, remove the stain with neutral
washing agent with a dry cloth.
b. Never use strong agents such as benzene and thinner to clean the system.
c. If heavy stains are present, moisten a cloth with diluted neutral washing