WORKING ADVICE
General Information
The reception lens 7 and the laser beam
outlet 6 must not be covered when taking a
measurement.
The measuring tool must not be moved while
taking a measurement (with the exception of the
continuous measurement function). Therefore,
place the measuring tool, as far as this is
possible, against or on the measuring points.
Measurement takes place at the centre of the
laser beam, even when target surfaces are
sighted at an incline.
INFLUENCE EFFECTS ON THE
MEASURING RANGE
The measuring range depends upon the light
conditions and the reflection properties of the
target surface. For improved visibility of the
laser beam when working outdoors and when
the sunlight is intense, use the laser viewing
glasses(not supplied) and the laser target plate
(not supplied), or shade off the target surface.
INFLUENCE EFFECTS ON THE
MEASURING RESULT
Due to physical effects, faulty measurements
cannot be excluded when measuring on
different surfaces. Included here are:
– transparent surfaces (e.g., glass, water),
– reflecting surfaces (e.g., polished metal,
glass),– porous surfaces (e.g. insulation
materials),
– structured surfaces (e.g., roughcast,
naturalstone).
If required, use the laser target plate (not
supplied) on these surfaces.
Also, air layers with varying temperatures or
indirectly received reflections can affect the
measured value.
MESSAGE CODE
Message
code
Possible
Cause
Remedy
Err10
Battery too
low
Change batteries
Err15
Out of range
Measure target
within
the range
Err16
Received
signal too
weak
Use light color
target;
Hold Quick
Measure
more steady
Err18
Background
brightness
too high
Use dark colored
target
Err26
MAINTENANCE AND
SERVICE
MAINTENANCE AND CLEANING
Store and transport the measuring tool
only in the supplied package.
Keep the measuring tool clean at all times.
Do not immerse the measuring tool in
water or other fluids.
Wipe off debris using a moist and soft cloth.
Do not use any cleaning agents or solvents.
Maintain the reception lens 7 in particular,
with the same care as required for eye
glasses or the lens of a camera.
7. Direct the laser beam towards the second
target.
8. Press the button again.The second
measurement will be shown on the display.
9. Press the button again to activate the laser.
10. Direct the laser beam towards the second target.
11. Press the button again.The third
measurement and volume result will be shown
on the display.If you want to continue to
measure under this funtion,
press the button again.
EN
6
One button back to single measuring
Press button to back to single measuring.
Out of display
