Protech Systems PPC-7400, Operation Manual

Page: 79 / 118

Chapter 4 Award BIOS Setup
Page: 4-16
PPC-740X USER
′
S MANUAL
INIT DISPLAY FIRST:
This item allows you to decide to active whether PCI Slot or on-chip VGA
first.
BIOS FLASH FUNCTION:
This item allows you to enable the BIOS Flash function.
IDE HDD BLOCK MODE:
Block mode is also called block transfer, multiple commands, or multiple
sector read/write. If your IDE hard drive supports block mode (most new
drives do), select Enabled for automatic detection of the optimal number of
block read/writes per sector the drive can support.
POWER ON FUNCTION:
This item allows you the select power on event.
KB POWER ON PASSWORD:
This item allows you to set the keyboard power on password.
HOT KEY POWER ON:
This item allows you to select the hot key of the keyboard power on.
The choice: Ctrl-F1~F12.
ONBOARD FDC CONTROLLER:
Select Enabled if the system has a floppy disk controller (FDC) installed on
the system board and you wish to use it. If you install and-in FDC or the
system has no floppy drive, select Disabled.
ONBOARD SERIAL PORT 1:
ONBOARD SERIAL PORT 2:
ONBOARD SERIAL PORT 3:
ONBOARD SERIAL PORT4:
Select an address and corresponding interrupt for the first and second serial
ports.
UART MODE SELECT:
This item allows you to select UART mode.