4
2
1
3
5
6
7
8
PORT SPECIFICATION CHART
This chart is used to specify the location of the ports for each different vessel configuration in
the system. Always use this chart to specify proper side port locations. If you have any
questions, call the factory. Please use this chart as follows:
1) Determine proper port sizes using the multiple port guide.
2) Determine the proper port location for each vessel.
3) Starting at the serial number end, enter the location of the first port followed by the
port size. Repeat this for each port on the serial number end.
4) Moving to the opposite end, enter the location of the first port followed by the port
size. Repeat this for each port on this end.
5) Enter this information at the bottom of the ordering page for each vessel
configuration.
6) Sign and date the ordering page before you send it in.
NOTE: Two ports per end maximum, diametrically opposed
Ports 1 and 5 are located on the bottom of the shell.
Port Size Code
J
2-1/2” Grooved End
K
3” Grooved End
Serial Number End
Opposite end
EXAMPLE
This example is provided to show you the proper way to specify your port locations. Please
understand this example before filling out the ordering page. For questions concerning the use
of this chart, please call the factory.
At the serial number end of the vessel a 2-1/2” port is needed facing left (9:00 o’clock) and a 3”
port is needed facing right (3:00 o’clock).
At the end opposite the serial number a 2-1/2” port is needed facing left (9:00 o’clock) and a 3”
port is needed facing right (3:00 o’clock). See illustration at left.
Serial Number End
Opposite end
2
J
4
K
6
J
8
K
2
8
4
6