Protec COMPACT2 SX 2, Operation Manual, Page: 6 / 58

6 COMPACT 2
TM
Installation
®
Installation
1. Requirements for installation
a. Fresh water connection: Stop cock with 3/4" outer-thread diameter (washing
machine connection), Water pressure 2 - 10 bar (29 - 145 psi).
b. Drainage connection: Plastic tube - inner diameter 50 mm ”or larger. A ven-
tilated syphon which serves as odour preventor should be included in the
planning. The drainage tubes should be installed with a fall of minimum 5 %.
Local Water Authorities regulations should be complied with.
c. Electrical connection: Fused wall socket with earth connection according to
electrical data (see technical specifications, page 5 ). It is also required to
install an earth-leakage switch (with 25 A / 30 mA nominal error current).
2. Installation of processor
a. Unpack and assemble base table/ base cabinet respectively according
enclosed manual.
b. Unpack Processor and mount onto base table/ base cabinet respectively
according to manual. Remove the transport securing bars of the roller-racks.
Fit the gear and dryer plates to the water/dryer-rack.
Electrical connections should be carried out according to reg-
ulations by an electrician.
1
6
3
2
5
8
7
4
Depending on model type the Compact 2 has either an open
stand or like shown here a closed cabinet.
1 Machine cover
2 Light protection cover on film infeed
3 Control panel
4 Power switch and main fuses
5 Replenishment tanks
6 Stop cock of water
7 Connections for freshwater, replenishment and
drainage respective overflow
8 Levelling feet