PRS 500 B User Manual
5014-0-0002
PROTEC GmbH & Co. KG, In den Dorfwiesen 14, 71720 Oberstenfeld, Germany
14 from 42
2.1
General safety notice
2.1.1
Requirements for operation
WARNING!
Class I ME device
To reduce the risk of electric shock, this unit is designated exclusively for
connection to a supply network with protective earth.
The power for the components of radiographic system PRS 500 B is
designated to be exclusively supplied through a direct connection to the
available X-Ray generator. The X-Ray generator is required to offer a minimum
of two connection ports with 230V 50/60Hz.
The X-ray Generator of the System is directly connected to the power supply
(see technical description of the Generator)
The radiographic system PRS 500 B with stand is am ME Class I product.
This device contains no on/off switch. The PRS 500 B is directly connected to
the X-Ray generator and is switched on/off through the switching on and off
of the generator itself. In order to disconnect the PRS 500 B from the power
the connected X-Ray generator must be shut off.
2.1.2
Operating of the radiographic system
When having troubles with operating the X-ray system PRS 500 B, immediately call the Service of
PROTEC or an authorized service and stop the using of the system.
2.1.2.1
Operating type
The PRS 500 B is not designate for continuous use.
2.1.3
Operating personnel
The radiographic system PRS 500 B with stand should only be operated by personnel who are trained
in accordance with the corresponding national regulations in the use and operation of diagnostic X-
Ray systems.
NOTE
Only properly trained and authorized personnel are allowed to work with the
radiographic system.
The user, as well as the service personnel, must pay attention to the warnings, notices and safety
instructions located on the device and in the user manual. Failure to comply with the information
provided can lead to injury.
NOTE
Operating personnel are required to acquaint themselves with all warnings
(warning signs) located on the device. They serve to ensure the safety of the
operator as well as others and set a basic for orderly operation.
