Prostage WAHryTone, User Manual

Page: 15 / 31

Sequencer
Software
MIDI
Interface
MIDI
Out
Page 15
7 Creating Presets with MIDI Commands | Sequencer Software
The presets of the WAHryTone can be edited using a sequencer software. Of course, a MIDI interface must be
available too and MIDI knowledge is required.
MIDI cable
7.1 Controling the Parameters using Control Change Commands
The following CC (Control Change) commands are used to adjust the parameters (more about the parameters in
chapter 8):
CC 07 (0-127) WahWah effect (operating mode [

WahWah]), or volume (operating mode [

Volume])
CC 67 (0-127) Effect Position at Preset Recall
CC 80 (0-8)
Operation Mode *
CC 81 (0-99) Auto Wah / Tremolo Time fine (in 1/1000 Sec.) ***
CC 82 (0-127) Auto Wah / Tremolo Time coarse (in 1/10 Sec.)
CC 83 (0-127) Dynamic Wah Threshold
CC 84 (0-127) Dynamic Wah Sense
CC 85 (0-127) Dynamic Wah Decay
CC 88 (0-6)
Auto Wah / Tremolo Mode **
CC 89 (0-127) Range, in Operation Mode [

WahWah] 180%...0%, in [

Volume]; -100 dB...0 dB
CC 90 (0-127) WahWah Input Gain (-15 dB ... +4 dB)
CC 91 (0-127) WahWah Q Factor (Wide ... Steep)
CC 92 (0-127) WahWah Coil Rating (Flat ... Sharp)
CC 93 (0-127) WahWah Frequency (162 / 486 Hz ... 2,2 / 6,6 kHz)
CC 94 (0-127) Contour Boost Frequency (450 Hz ... 3,4 kHz)
CC 95 (0-127) Output Gain (0 dB ... +25 dB)
CC 14 (off/on) “Tap” (factory default is CC14. However, this value can be modified using Sysex commands)
CC 68 (off/on) "Dynamic Wah invert direction"
CC 72 (off/on) “Preset Recall updates Position” off / on
CC 73 (off/on) “Curve” linear / logarithmic
CC 74 (off/on) “True Bypass” on / off
CC 75 (off/on) “WahWah / VCA” operating mode
CC 76 (off/on) “WahWah” disabled / enabled
CC 77 (off/on) “Tuner” disabled / enabled
CC 78 (off/on) “Contour Boost” disabled / enabled
CC 79 (off/on) “Auto Enable” disabled / enabled
For CC 14, 68 and 72 to 79, the controller values are 0 = off, 127 = on.
NOTE => Depending on the operation mode, not all the parameters affect the sound.
* Operation Modes: ** Auto Wah / Tremolo Modes: *** Auto Wah Time
0 - WahWah 0 - Auto Wah off If both values are set to 0,
1 - WahWah & Contour Boost 1 - Sine then the time will not up-
2 - Contour Boost 2 - Peak date when preset is changed
3 - Treble Boost 3 - Sawtooth Increasing Instead, the time from pre-
4 - Tremolo 4 - Sawtooth decreasing vious preset will be kept.
5 - Volume 5 - Square
6 - True Bypass 6 - Dynamic
7 - Buffered Bypass 7 - Frequency
8 - Tuner