Installation
ProSoft Technology, Inc.
Page 11 of 30
July 24, 2014
3
Installation
3.1
Mounting
The Master and Slave units are DIN-rail mountable. The Repeater units are
Panel Mount. The Master must be located near the PLC. The Slaves should be
located in the vicinity of the Remote I/O nodes.
Warning:
Please follow all safety instructions when installing this or any other
electronic devices. Failure to follow safety procedures could result in damage to
hardware or data, or even serious of death to personnel. Refer to the
documentation for each device to be connected to verify that suitable safety
procedures are in place before installing or servicing this device
.
3.2
Powering the Devices
The power terminal is located on the front of the device as shown in the following
diagram. This is a 4-pin power connector.
