2
Operating Instruction
1.
Place the desoldering iron gun in the holder separately. Then connect the plug
to the receptacle on the station and turn clockwise to tighten the plug nut. Check
that the power supply is corresponding to the specification on the type plate and
the power switch is on the “OFF” position. Connect the control unit to the power
supply and switch on the power. Then a self-test is carried out in which all
display elements are switched on briefly. The electronic system then switches
on automatically to the set temperature and displays this value.
2.
If not use for about 10 minutes ,the desolering station will be automatically into
sleeping mode and the temperature is reduced to 200 C, this for prolonged the
life of the suction nozzle and the heating element; Shake or pick up the
desoldering Iron gun, can start the working again.
3.
The display and temperature setting
①
.
Shows the actual temperature of the desoldering tip.
②
.
Shows the setting temperature: Pressing the “UP” or “DOWN” button can
switch the digital display to the set point display. The set-point can be
changed for ±1
℃
by tapping the “UP” or “DOWN” button. Pressing the
button will change the set-point quickly. The digital display will return
automatically to the actual value and the iron will reach to the setting
temperature quickly.
③
.
℃
/
℉
display: Switching the temperature display from
℃
to
℉
by
pressing the
“
*
”button and then the electronic system will display the
actual temperature
①
and setting temperature
②
in
℉
, and vice versa.
④
.
When the actual temperature on the desoldering tip is less than the
set-
point, “HEAT ON” will display and make the desoldering tip heating
up.
⑤
.
When the absolute offset is more than ±10
℃
between the actual
temperature and the set-point on the desoldering tip or the nozzle,
“WAIT” will display. It means that the temperature electronic control
system is not in the stable situation, we should wait a moment to let the
“WAIT” disappear.
⑥
.
When
“-----” & “ERROR” display, there may be a trouble on the system,
or the desoldering iron gun is not connected to the control system
correctly.
Safety Instruction
1.
The manufacturer assumes no liability for uses other than those described in
the operating instructions or for unauthorized alterations.
2.
The operating instructions and cautions should be read carefully and kept in an
easily visible location in the vicinity of the control system. Non-observance of
the cautions will result in accidents, injury or risks to health.
