6
PRS-UM-PPSM-EN-Rev.03-10.04.2020
Diagram 2: Panel cover plastic screw
To prepare cable entries, remove plastic covers from top or bottom of the panel. Then drill the holes
for cable entry and install cable glands to the holes you made it. Make sure you are using an
adequate IP66 rate cable gland to assure the box ingress protection is not compromised. The panel
box is modular and can be used with different assemblies. Prosense recommends having cable
entries from the lower side. Electronic board is located in the front cover of the panel. The power
supply is located at the back of panel box. The power must be connected to this power supply. If the
installation requires the connection to a backup battery, place the battery to lover right side of the
panel inside.
Diagram 3
: Panel body
Plastic screws
Plastic screws
Backup battery connectors and fuse
Wall mounting hole
Power supply
N L G V- V+
Wall mounting hole
Wall mounting hole
Wall mounting hole
Main power entry and fuse
Space for backup
batteries
Power supply LED
Power supply output
adjustment switch
