DVR User Manual
27
Step 3
: Enable the auto report in the ECMS/NVMS when adding a new device. Then input the
remaining information of the device in the ECMS/NVMS. After that, the system will auto allot
a Device ID. Please check it in the ECMS/NVMS.
Step 4
: Input the above-mentioned server IP, server port and device ID in the server interface.
Then click “Apply” button to save the setting. Now, the ECMS/NVMS system will
automatically connect this device.
4.6.5 Other Settings
If your DVR is set to use PPPoE as its default network connection, you may setup DDNS to
be used in connection. The setting steps are as follows:
Step 1
: Enable DDNS server.
Step 2
: Select DDNS server.
Step 3
: Enter user name, password and host domain name of the registered website.
Step 4
: Click “Test” button to test the effectiveness of the relevant information.
Step 5
: Click “Apply” button to save the setting.
Fig 4-26 Network Configuration-Other Settings
Note:
The domain name selected by user is a banding domain name of DVR. User
should logon the website which provided by the server supplier to register a user name
and password and then apply for a domain name online. After the successful
application, user can access the device from the IE client by inputting that domain
name.
Enable UPnP:
Select UPnP here and then enable UPnP function in your router. Therefore,
there is no need for you to forward LAN IP address and port in the router in connection of
internet. After that, you can check the WAN IP address in the router.
Domain name Registration
（
Take
www.dvrdydns.com
for example
）
Step 1: Input
www.dvrdydns.com
in the IE address bar to visit its website. Then click
“Registration” button to register as shown below.
http://www.e-camere.ro/dvr/PROsee/PD-D08SH