Page 3 of 4
MAINTENANCE
•
Check accessory is securely attached whenever you refit it to the vehicle. If the unit feels
loose, refer to the fitting instructions and readjust.
•
Regularly check all fasteners. This includes all attached accessories and roof racks.
•
If contaminated with oil, fuel or acid remove with hot soapy water.
•
If the ratchet mechanism becomes stiff in use, a small amount of lubrication applied to the
moving parts will ease operation.
CAUTION
•
Ensure that all loads are distributed evenly across the roof racks and are fastened securely.
•
A loaded roof rack system can alter the performance of your vehicle. Be especially aware
of the effects of side winds, changing of direction, and braking performance. Avoid rapid
acceleration and deceleration. Drive Carefully.
•
Make sure all loads are securely fastened with non-elastic straps. Check regularly during
longer journeys.
•
Never drive into a car wash with the roof rack system fitted.
•
Do not exceed the vehicle manufacturer’s roof load rating. Total load equals weight of roof
racks + acces cargo/equipment.
•
Must not be used for lifting. Protect from abrasion and friction. Do not tie knots in the
straps. Do not use a damaged strap.
•
150kg lashing capacity on the polypropylene webbing.
4
3
Fasten an M10 eye bolt and 2 x M10 washers onto
each M10 T-nut. Tighten eye bolt. A tool such as
a screwdriver through the eye of the bolt may be
used for leverage to tighten the eye bolt firmly.
Hook straps onto the eye bolts and fasten the free ends
to the cam buckles and ratchet.
Ensure the ring is in the centre of the wheel.
Tighten via ratchet.
TOP VIEW
WARRANTY & DISCLAIMER
Yakima Australia Pty Ltd ABN 58 154 440 221
17 Hinkler Court, Brendale QLD 4500
Tel: 0800 4776 722 (NZ) or 1800 143 548 (AU)
Email: [email protected] or [email protected]
1. Where the product is supplied to the customer for other than business purposes within the meaning of section 43 of the
New Zealand Consumer Guarantees Act 1993, the provisions of that Act shall apply. It is important that anyone who
fits or uses this product does so in accordance with the manufacturer’s instructions.
2. Where the product is supplied to the customer for business purposes within the meaning of section 43 of the New Zealand
Consumer Guarantees Act 1993, the provisions of that Act and all other representations or terms (including any conditions
or warranty expressed or implied by law, statute or otherwise) not expressly included in this leaflet are hereby expressly
excluded shall have no effect and the clauses (a) and (b) shall apply.
3. Subject to the
Additional Information (Australia)
, where the product is supplied and purchased in Australia, the following
shall apply:
(a). THE SUPPLIER WARRANTS the product to be free from defects in materials and/or workmanship for a period of three (3)
years from the date of original purchase (the warranty period). Proof of purchase is required. Subject to the limitations
and exclusions set out below, the Supplier hereby agrees to remedy any defects in materials or workmanship becoming
apparent during the warranty period, by replacing or repairing any defective product or component (at its option) free of
charge to the purchaser in respect of replacement parts or labour. Any defective product or component must be notified
and where practicable, returned at the purchaser’s expense to the Supplier immediately upon discovery of the alleged
defect and no attempt made on the part of the purchaser to repair it.
Cont. next page
INSTALLATION WITH PRORACK S-WING AND INTERNATIONAL T-SLOT CROSSBARS (CONT.)
