Page 3 of 6
6100010663 PR3105 - Rev3
Ensure the carriers sit vertically on the bars
7
Tighten the Knobs
8
Secure straps
11
In some cases, the
bracket and the bail
may not be parallel
If the bolts seem
too short, use
the longer bolts
included in this kit
(longer bolts)
BOLTS MUST NOT EXTEND ABOVE THE KNOBS.
If bolts extend above the knob, you
must use the shorter bolts
OK
OK
Adjust foam pads to support boat at contact points
9
Note: Some lacquer hull
fi
nishes may stick to pads.
Protect with soft cloth.
Load the boat, and tie it down
10
• Loop strap around hoop of carrier.
• Bring straps up and over boat so that they
hang in front of the boat.
• Slide buckle up so that it hangs at top edge of boat.
• Thread end of strap around tower or crossbar.
• Press open buckle
and insert end of
strap.
• To tighten straps,
hold and pull.
• Secure the loose
ends.
Antenna on the
roof may need
to be removed
to prevent
interference
with long loads
