P E R C H H E I G H T A D J U S TA B L E D E S K
INITIALIZATION/RESET
The desk must be initialized/reset after any of the following:
- After assembly
- After disconnection from the power supply
- After any impact on the table top.
To initialize/reset, move the table to the lowest position by pressing the DOWN button on the handswitch until the columns reach the lowest
position. Press the DOWN button again until the table moves slightly down to the machine zero point and back up to the operation zero point.
Release the DOWN button. If the button is released too soon, the table legs will not move up. Repeat the reset process.
The control box is programmed with a parameter file which controls the table legs' lower and upper travel limits. Under no circumstance should a
control box from one table be moved to another.
NORMAL HANDSWITCH OPERATION (for all handswitch types)
By pressing the UP or DOWN buttons, the table will move up or down to the desired position. Once the desired position is reached, let go of the
UP or DOWN button. The table legs will stop once they reach the lower or upper height limits.
SHELF AND CONTAINER STOPS
Container and shelf stops are safety positions that cannot be run over during normal operations, so that collisions with known, permanently
present hindrances can be prevented. The container stop limits the movement height downwards (minimum height) and the shelf stop limits the
movement height of the table upwards (maximum height). If an attempt is made to set the container stop or shelf stop too close to the middle,
the controller signals this with 6 quiet click sounds. Note: This function is configuration-dependent and is not available with every controller.
With the additional stops, the safety of the table system can be increased, in that the possible movement path is restricted.
SET UP SHELF AND CONTAINER STOPS
Move the table using the arrow keys into the desired position. Press both arrow keys at the same time. The controller confirms with a quiet,
double-click. The absence of this signal means that setting is possibly not permitted.
DELETE THE CONTAINER STOP
Keep the down arrow key pressed. The table stops automatically upon reaching the container stop. Press both the arrow keys at the same time.
The controller confirms with a quiet, double-click.
DELETE THE SHELF STOP
Keep the up arrow key pressed. The table stops automatically upon reaching the container stop. Press both the arrow keys at the same time.
The controller confirms with a quiet, double-click.
WARNING
With an initialization movement prompted by the controller, the reset position is always approached directly. Any container stop or safety stop
that is present is ignored.
First, remove all hindrances below the table and pay heed to the increased risk of injury.
Only trained personnel should carry out setting and deletion of container and shelf stops. There is a danger of injury from wrong setting or re-
moval of the Stop positions, and a danger of the table getting destroyed.
O P E R AT I O N I N S T R U C T I O N S
proproffice.com 7