9
10
HOW TO DO 360º STUNT ROLLS
1. In order to make your X02 do 360º rolls you must fully charge your battery.
Note: The X02 will not do 360º stunt rolls in Mode1 and when the drone is running low
battery (The LED lights on the drone start flashing).
2. Once you are ready to attempt a 360º roll, short press the "STUNT" button on the top right hand side
of your controller (see Remote Diagram D), you will hear continous beeping sounds. This means you
are now in “STUNT MODE”
3. Now quickly move your right control stick in any of 4 directions; up, down, left or right and your
X02 copter will instantly roll in the associated direction(See diagram E). After stunt roll the beeping
sounds will stop.
D
360˚Stunt-Roll
E
Your X02 comes equipped with an onboard digital camera that takes both video and still photographs. Now
you can have hours of fun creating aerial photography and videos for family and friends.
WHAT YOU WILL NEED TO GET STARTED USING YOUR CAMERA
1. One microSDHC card (not included)
2. One microSDHC card reader (included)
3. One Computer with USB port and Windows Media Player or other Media player that can play AVI files
(not included).
FORMATTING YOUR microSDHC CARD
Before you can begin to take videos or digital photographs you must first format your microSDHC card. To
format your microSDHC card simply place the microSDHC card into the included USB card reader and plug
it into your computers USB port (See diagram 1 and 2 below). After a few moments an icon will appear on
your Desktop. Right click on the Icon and follow instructions to format your microSDHC card.
INSTALLING THE microSDHC CARD IN YOUR X02 QUADROCOPTER
• Keep X02 power turned off.
• Place the formatted microSDHC card into the side of the quadrocopter’s digital camera port( see diagram
3 below). Push gently and consistently until you hear and feel the microSDHC card “click” into the digital
camera slot.
• Turn on your X02 power and properly sync it to the Controller (see HOW TO SYNC YOUR DRONE on page 4 ).
• When you have successfully installed your microSDHC card and your quadrocopter is powered up, the
flashing red LED lights on the back of the drone will turn solid.
NOTE: If you see the red LED lights keep flashing, it means you have not installed your microSDHC card
correctly or there is a problem with your card. You can repeat the above steps again. If you continue to
encounter problems call our customers service line at 949.566.9573 Ext 1 for assistance.
TAKING DIGITAL PHOTOS
To take photographs simply short press the CAMERA/VIDEO button on the top of the controller (refer to
CONTROLLER DIAGRAM on pg. 3), when you push the button you will hear a short "beep" and the green
indicating LED light will flash 3 times indicating that 3 pictures have been taken.
RECORDING VIDEOS
To record a video, first make sure that your quadrocopter is fully charged and that you have correctly
installed the microSDHC card in the quadrocopters camera port. Begin recording a video by pressing the
CAMERA/VIDEO button for a few seconds (see CONTROLLER DIAGRAM on page 3). The red LED lights on the
back of X02 will flash constantly to indicate that you are in video mode and the camera is recording. To stop
the video recording, long press the button again. The red LED lights on the back of the camera will change
to solid indicating that video recording has stopped and the Camera is in ready mode again.
USING YOUR ON BOARD CAMERA AND VIDEO RECORDER
microSDHC card
goes in back slot
Diagram 3
Diagram 2
Diagram 1
IMPORTANT NOTICE : You can not take photos and videos at the same time.
microSDHC card facing up
microSDHC card facing down
