O
P
Q
R
7
8
UNDERSTANDING TRIM ADJUSTMENTS
Forward/Backward Trim
• If your Proton™ is drifting forwards or backwards, you may need to adjust the FORWARD/BACKWARD
TRIM (see diagram O).
• If your Proton™ drifts forward, push and release the BACKWARD TRIM button back repeatedly
until the motion stops and proper flight is maintained.
• If your Proton™ drifts backwards, push and release the FORWARD TRIM button forward in the
same manner until the problem is resolved.
• From time to time you may have to adjust the FORWARD or BACKWARD TRIM buttons to ensure the
Proton™ will hover in mid-air and respond accurately to your commands.
Right/Left Trim
• If your Proton™ is drifting left or right, you may need to adjust the LEFT/RIGHT TRIM button
(see diagram P).
• If your Proton™ drifts left, push and release the RIGHT TRIM button repeatedly until the motion
stops and proper flight is maintained.
• If your Proton™ drifts right, push and release the LEFT TRIM button in the same manner until the
problem is resolved.
• From time to time you may have to adjust the LEFT or RIGHT TRIM buttons to ensure the
Proton™ will hover in mid-air and respond accurately to your commands.
LEVEL SURFACE GYRO CALIBRATION
If the aircraft becomes unstable during the course of flying, or after a
crash, you may need to recalibrate the onboard gyro chip.
To do so, place the Proton™ on a flat level surface. Start by syncing
the controller with the quadrocopter. Next, pull the right control stick
on the remote all the way down and to the right (approximately 45º)
and hold for a couple of seconds. The LEDs on the Proton™ will flash
quickly and then turn solid when released. This indicates your drone
has been stabilized (see diagram Q).
LOW BATTERY WARNING
If the power indicator LED on the remote lights up it means you are running at low voltage and need to
land the aircraft slowly and replace the batteries in the controller.
If the LED lights on the quadrocopter begin flashing it means you are running at low voltage and you need
to land the aircraft slowly and recharge the quadrocopter unit.
WARNING:
Do not attempt a 360º flip when you are given a low voltage warning
PERFORMING A 360º STUNT ROLL
Once the Proton™ is airborne,
1. Press the right control lever straight down.
2. Move the lever in the direction you wish to perform the 360º roll (see diagram R).
