Front Rotor Blades
Rear Rotor Blades
Charging Socket
Charging Socket
On/Off Switch
PROTON™ DIAGRAM
PROTON™ REMOTE DIAGRAM
Landing Gear
Forward Trim
Backward Trim
Throttle Control
Direction Control
Power
Indicator
Light
Power On/Off Switch
Left Trim
Right Trim
3
4
SYNCING YOUR PROTON™
Important! When syncing your Proton™ quadrocopter with the controller always make sure that
the quadrocopter is on a flat level surface and that your digital trim settings are in the center
position. This ensures that the 6 Axis gyro is properly programmed to mimic your trim settings.
Your Proton™ utilizes an automatic 2.4G channel selection system that allows up to 8 people to fly side by
side in the same wireless range with no interference.
For One-Person Play:
1. Before starting, make sure that the power on both your controller and Proton™ are in the OFF
position. Make sure that there are no other 2.4G devices in the area as well.
2. Turn ON the Proton™ and set it down on a flat surface. The LED indicator lights of the Proton™
should begin to flash rapidly.
3. Turn ON the remote, you will hear two short beeps. The Proton™’s LED lights should now flash slowly.
Push the throttle on the left all the way forward(1 beep) and then pull the throttle all the way back.
A 2nd beep will sound and the lights should turn to solid. This indicates your controller and the
quadrocopter are successfully synced. If not, repeat above steps.
For Multi Person Play:
4. Before starting, make sure that the power on all Proton™ drones and Controllers are in the OFF
position. Make sure that there are no other 2.4G devices in the area.
5. Each person will have to sync their Proton™ individually at a different time to avoid interference.
Follow steps 1 to 3 above making sure that no one else is syncing at the same time.
6. After syncing a player’s Proton™, it should be left ON until all players have synced their Proton™
quadrocopters.
7. Should there be a mistake or interference, all players must turn off their controllers and Proton™
quadrocopters for up to 60 seconds and then begin the process again.
PREPARING FOR FLIGHT
• Verify that there are 2 “AAA” batteries inside the remote control unit and the Proton™ has been
fully charged.
• Make sure your Proton™ and controller are both turned on.
• Make sure to be in a large space with an open radius of at least 50 feet.
• Make sure the empty space has no obstacles and water close by. Set your Proton™ on a clean flat
surface before take-off.
DO NOT ATTEMPT TO FLY YOUR Proton™ IF THERE IS RAIN, SNOW, HEAVY WINDS, THUNDER OR LIGHTNING
OUTDOORS. IT COULD DAMAGE YOUR PRODUCT AND POSSIBLY EVEN CAUSE BODILY HARM.
FLYING TIPS
• It is recommended that you operate the Proton™ in a wide open space. The ideal space should have a
200 foot radius.
• Parental guidance or adult supervision is suggested at all times.
• If you are flying the Proton™ with others, make sure all spectators are behind you.
• For best performance, it is recommended that you operate the Proton™ in zero wind conditions,
as wind can greatly affect the performance of the aircraft.
DO NOT FLY YOUR PROTON™ IN FOUL WEATHER!
WARNING
