________________________________________________________________________________
6
–
Lift trolley Lift&Drive
325P+
Assembly
Protective footwear should be used when assembling the lift trolley, to prevent injuries if parts are
dropped.
1. Place the wheel frame and cross-member on the floor and activate the wheel brakes.
2. Slide the columns onto the bracket on the cross-member. The screw bar on the
bracket fits the slots on the back of the column.
3. Place the power pack on the ground next to the trolley. Connect the motor cable and
the remote control to the power pack.
4. Press the up button on the remote control to make the columns go down to its
lowest position. The column should stand directly on the cross-member. Tighten the
6 screws at the bottom. Disconnect the power pack.
5. Fit the lower and the upper bracket for the power pack into the two middle slots on
the back of the columns. Move it downwards until it stops.
6. Fit the handlebar into the slot on the back of the column and lock it so that the
power pack will fit underneath.
Don’t tightened too hard.
7. Fit the bracket (nr 7) into the slot on the back of the column. Position it in the top
end of the columns tightening the nuts by hand.
8. Slightly tighten the lower bracket for the power pack. Fit the power pack on the
lower bracket and lock it with the upper bracket by tightened the black knob. Plug
the motor cable contact into the matching socket on the power pack. Connect the
remote control and place it on the handlebar.
9. By pressing down on the remote control, move the slides to the lowest position and
mount the bracket for the attachment joining the two slides.
10. Move the slides with the bracket by pressing up on the remote control. Stop in the
middle of the columns.
11. Tighten the nuts on the back of the cross-member, power pack bracket and the top
bracket (18 nuts) but not too hard (15 Nm), with a 13 mm wrench.
12. Attach the load carrier with the supplied screws and washers in the slide of the
column.
13. Perform a static load test, with 1.25 x the maximum load.
(Move the load carrier to the middle of the column and apply the load.)
14. The lift trolley is now ready to use.
2.1
Disassembly and scrapping
To disassemble the lift trolley, follow the instructions in section
Assembly
, but in reverse order.
When the lift trolley is due for scrapping the machine, complete with batteries, should be handed
in to a recycling centre or Pronomic to ensure reuse and safe handling of all parts.
