PRONAR PRONAR 5110, Operator'S Manual

Page: 104 / 122

SECTION 6: MAINTENANCE
6-22
OPERATION No. 24. Change oil and oil filter in gear box and rear axle.
ATTENTION: Before changing oil filter park tractor on a level surface and brake with
parking brake. Change oil directly after finishing work, after switching off engine.
Figure 6-35
4
Figure 6-36
In order to change oil:
-
unscrew inlet plugs 2 and drain plug 1 in gearbox box and rear axle;
- pour oil to previously prepared basin
-
change oil filter 4 (located on right side of gearbox).
-
tighten drain plugs 1;
-
pour fresh oil through inlet plug 2 to the required level
-
tighten inlet plug 2;
OPERATION No 25
. Changing oil in front axle drive body and reducers.
Change oil after finishing work and stopping the engine. Before changing oil filter park tractor on a level
surface and brake with parking brake.
1
Figure 6-37
2 3
In order to change oil:
- set wheel so that control-drain-inlet tap of reducer 1 is at the lowest position. Unscrew drain tap and
drain oil to previously prepared basin
- repeat oil draining operation for second wheel reducer.
- - unscrew drain tap of front axle body 3
-
pour oil to previously prepared basin
-
close drain tap 3.
-
set wheel so that control-inlet cap of reducer 1 is at the wheel cross-section axis.
- pour new oil to the level of the lower edge of the inlet control openings of reducer 1 and body 2;
-
screw up all inlet control taps.