PRONAR GP200, Operator'S Manual

Page: 41 / 66

SECTION 4 PRONAR GP200
4.5
4.3 HITCHING TO MULTIFUNCTION ARM
PRONAR GP200 branch cutting saw can be hitched to WWP600, WWP500, WWP500U or
WWP500UH multifunction arm.
ATTENTION
Before hitching the branch cutting saw, the user must carefully read the operator's
manuals of the branch cutting saw, tractor (carrying vehicle) and multifunction arm and
observe all instructions contained in the manuals.
DANGER
When hitching, there must be nobody between the machine and the tractor/carrying
vehicle.
Exercise caution when hitching the machine.
DANGER
Before hitching the branch cutting saw, turn off the tractor/carrying vehicle's engine and
remove the key from the ignition. Ensure that unauthorised persons do not have access
to the tractor/carrying vehicle cab.
Check technical condition of the branch cutting saw's guards and general technical
condition of the machine.
In order to hitch the branch cutting saw to the multifunction arm head (FIGURE 4.1), proceed
as follows:
•
Control the multifunction arm and bring its head (1) close to the support beam (2) of
branch cutting saw.
•
Using the control panel, set the multifunction arm head (1) at the same height with the
support beam of the branch cutting saw.
•
Immobilize the tractor/carrying vehicle and prevent it from moving.
•
Connect the multifunction arm head (1) to the support beam of the branch cutting saw
(2) using four fixing bolts (3).
•
Connect quick couplers of hydraulic conduits (4) of multifunction arm to quick couplers
(5) of the hydraulic motor of the branch cutting saw.
•
Raise the branch cutting saw using the control panel of the multifunction arm.