FastTrak SX4000
8
Step 5: Driver Installation
This section details the FastTrak SX4000 driver installation when used with
various operating systems. The software includes the driver necessary to
identify FastTrak SX4000 to the operating system.
Installing Driver During New Windows XP Installation
1. Start the installation: Boot from the CD-ROM. Press F6 after the
message “Press F6 if you need to install third party SCSI or RAID driver”
appears.
2. When the Windows XP Setup window is generated, press S to specify
an Additional Device(s)
3. Insert the Promise Technology driver diskette into drive A: and press
Enter.
4. Choose
WinXP Promise FastTrak SX4000™ Series Controller
from the
list that appears on screen, and then press the Enter.
5. Press S to use the driver on the floppy disk and then press Enter to
continue with installation.
6. The Windows XP Setup screen will appear again saying “Setup will load
support for the following mass storage devices:” The list will include
WinXP Promise FastTrak SX4000™ Series Controller.
NOTE:
If you need to specify any additional devices to be installed, do
so at this time. Once all devices are specified, continue to the next step.
7. From the Windows XP Setup screen, press the Enter. Setup will now
load all device files and then continue the Windows XP installation.
