FastTrak S150 TX4
4
Step 2: Install the FastTrak Card
The FastTrak TX4 Serial ATA RAID card fits into any available PCI slot on your
PC’s motherboard (see Figure 1, below):
•
32-bit PCI slot (must be PCI 2.2 or 2.3 compliant)
•
The 32-bit portion of a 64-bit PCI slot
1. Remove the cover of your system.
2. Remove the inside slot cover of an available 32-bit PCI slot on the
motherboard.
3. Install the FastTrak Serial ATA RAID card into the open slot (see Figure 1
below). Secure the bracket to the system’s frame.
4. Attach your system case’s 2- or 4-pin LED cable to the LED connector on
the FastTrak S150 TX4 RAID card (see Figure 2, on page 6). Make sure
that pin 1 on the connector is aligned with pin 1 of the cable.
5. Fasten the controller card bracket to the system case (see below).
Figure 1.
Insert the FastTrak card into an open PCI slot
