SuperSwap Manual
8
with two matching sets of numbered stickers. Place one sticker on the front of
the drive housing assembly and the matching numbered sticker on the front of
the drive carrier.
Figure 2-3: Drive Carrier Assembly
LED Messages
This section provides information on how to interpret LED display codes as
reported by the SuperSwap
3
when connected to the Promise SuperTrak66.
Two LEDs appear on the front of the SuperSwap housing assembly:
Power/Drive Status LED (left) and disk activity LED (right).
Power/Drive Status LED
Display
Means
Green*
Drive is OK
Amber (orange)
Drive is rebuilding and array is in “critical” mode
Red
Drive is bad or has failed and is now “offline”; array
may also have failed depending on RAID level
Black (dark)
No drive detected or no power to drive housing
* Indicates only Power On when SuperSwap is not connected to a
Promise SuperTrak66 card.
Disk Activity LED
3
Note: Users must obtain and install Promise FastTrak Driver v.1.30 or later in
order to implement L ED display functions for the SuperSwap enclosure. Go to
www.promise.com to obtain these drivers.
Drive Carrier
Drive Cable
Connector
Power
Connector
Access Cover
Pull-Away
Locking Tab
Pivoting Handle
