* Only if required by the operating instructions and if the mains
cable remains disconnected from the mains voltage. Make sure
that all protective equipment is refitted during operation.
Safety equipment
May only be removed by*:
Only in areas at risk from explosion: Vent screw with
filter
Qualified employee, electrical technician, ATEX
electrical technician, Service
"Hot surface" label
-
Earthing lines from motor and third-party electrical
parts
Electrical technician, ATEX electrical technician,
Service
Only with multiple pumps: Potential equalisation
lines between the drive units and base plate
Electrical technician, ATEX electrical technician,
Service
Other units and ancillary equipment: Their corre‐
sponding parts
Technical personnel, Service
* Only if required by the operating instructions and if the mains
cable remains disconnected from the mains voltage. Make sure
that all protective equipment is refitted during operation.
The operator must be able to:
n
Perform a risk assessment
n
Produce and attach a nameplate
n
Issue an EC Declaration of Conformity
n
Adapt the operating instructions, if necessary
n
Correctly install the motor
n
With ATEX motors: perform an ignition hazard assessment
Sound pressure level at maximum stroke length, maximum stroke
rate, maximum back pressure (water) - see "Evolution Data Sheet".
Small amounts of gear oil can evaporate out of the vent screws.
We recommend that you slightly ventilate the installation site.
Gear oil can escape from the pump in the event of specific faults,
damage, neglected maintenance, during commissioning and during
maintenance and repair work.
Additional safety equipment
Requirements, if the motor is installed
independently
Sound pressure level
Other emissions
Safety
8